None Output Hard-Clip Limits None Output Identification When the PNC-950 receives an OI instruction from the computer, 950 TERM.

Roland Camm-1 Pnc-950 Manual Uses Certain

RELEVANT DIRECTIVE: EC MACHINERY DIRECTIVE (89392EEC) EC LOW VOLTAGE DIRECTIVE (7323EEC) Typographic Conventions This manual uses certain typographic symbols, outlined below.

WARNING CAUTION CAUTION Never disassemble or Handle the power cord When pulling the power modify this product.

The following figure describes the location and content of these messages.

Since we wish you many years of productive use of your PNC-950, we ask you to read this manual and make yourself familiar with the PNC-950s operational procedures and requirements before running it.

Always be careful whenever the unit is in operation, so as not to risk getting fingers or hair caught in its mechanisms.

Movable Pinch Roller The tool carriage performs the (Left) cutting by moving the tool left This presses the media against right or updown.

SETUP LED PAUSE Key This lights up when the SETUP key is pressed.

Do not try to pick up or move the PNC-950 by grasping the top area of the unit -- be sure to use both hands to grip the PNC-950 securely on the left and right sides.

When the PNC-950 is connected to the computer through the serial port, be sure that the communication parameters for SW-1 to SW-6 are set correctly, matching the computer port settings.

Turn the cap clockwise to retract the blade or counterclock- wise to expose it.

Each scale line corresponds to 0.1 mm (about 0.004).

Roland Camm-1 Pnc-950 Full Turn Moves

One full turn moves the blade 0.5 mm (about 0.02).) Adjust blade holder before mounting on the tool carriage.

It is important to pull out the amount of sheet required for the intended design.

If you are using a different setup configuration (like in figures C, D, and E), then it will not be possible to feed the sheet correctly.

If you are using a rolled sheet, set the sheet base included with the PNC-950 at the back of the unit, place a rolled sheet on the sheet base, and pull out slack from the roll.

Once the sheet is loaded and the SETUP key has been pressed, the origin (0,0) is automatically set to a position near the left movable pinch roller on the left-hand side.

This cutting test allows you to determine whether the settings you have for the blade force are appropriate.

Pausing Cutting Operations PAUSE Key, PAUSE LED, and SETUP Key If you want to stop the PNC-950 momentarily while it is performing cutting, follow the procedure described below.

Cutting a Thick Sheet SW-8, one of the DIP switches located on the right side of the unit, is normally set to OFF (light).

If after the first test you feel that the sheet was not cutout clean enough, you can try gradually increasing the pen force until you have the optimum level.

The ROTATE LED is extinguished, and the origin returns to the point at bottom left.

The ROTATE function is also canceled when the power to the PNC-950 is turned off.

Since the design of the PNC-950 differs inherently from that of dedicated plotters, it does not accommodate functions such as high-speed plotting, automatic pen changes, pen dry protection, or the like.

Increasing the blade force temporarily allows the blade to perform better.

If the PNC-950 is not available as a selection, you may select either.

Roland Camm-1 Pnc-950 Driver For Mac